Call Routing

[EchoSpark]

Hi,

I have MD110 with TLU-44 as trunk connected to PSTN. How do i program such that a call from external (PSTN) direct to the auto attendant and make a call using least cost routing table.

Thanks.

 

[Isinor]

To route a call to an Auto attendant...

RODNI:ROU=...,TRU=...,DAY=..,NIG=...;

To set up LCR for outgoing calls is a bit more complex, it requires a lot more info from you.

Such as your Existing LCR setup or ROU's, DEST's, Number plan, Access codes to service providers, what calls to what providers, etc.




Regards
Isinor

 

[EchoSpark]

What i want is that an external caller should be able to get to auto attendant and dial 8(LCR code) to make another external call.Below is the data.

<LCDDP:TAB=FDT;
LEAST COST DESTINATION DATA
FICTITIOUS DESTINATION TABLE
FRCT TZONE PRE
1 1 7500
6 1 7505
END<LCDDP:TAB=DNT2;
LEAST COST DESTINATION DATA
NUMBER TABLE
ENTRY TRC PRE ACCT FRCT TOLL CBCS BTON TNS OSA
8011 1 0 6 111111000000000 0
81 1 0 1 111111000000000 0
9009 1 0 2 000100001000000 0
END


NADAP;
NUMBER ANALYSIS DATA
TYPE OF SERIES NUMBER SERIES

EXTERNAL DESTINATION CODE 7500 - 7509
75800 - 75999
770 - 776
778 - 779

LEAST COST ROUTING ACCESS
CODE NUMBER SERIES 8 - 9
EXTERNAL NUMBER LENGTH DATA
EXTERNAL NUMBER NUMBER LENGTH
7500 5 - 15
7505 7 - 19

<RODDPEST=7500&7505;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
7500 10 000500000001025000000000 0 5 0
20 1 000500000000025000000000 4 3 0 75009
21 2 000500000000025000000000 4 3 0 75009
7505 10 000500000001025000000000 0 5 0
20 1 000500000000025000000000 7 3 0 75009
21 2 000500000000025000000000 7 3 0 75009


<RODAP:ROU=10;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
10 SL60 H'00000310 H'15400000 H'06004010 NO

END

<ROCAP:ROU=10;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
10 711000000000001 7 3110000010 0 5 128 00151515 211110000031 111111


Thanks.

 

[EchoSpark]

I know i can use DISA to achieve this, but is there any other way?

 

[fcpli]

If I understand this correct, you want an incoming call
(TLU44) to have a RVA message (or just dialtone), and then dial out (SLP60), no DISA? If this is the case, there is a patch for such a functionality (at least BC10, maybe other versions too).

 

[EchoSpark]

Thanks fcpli, that is exactly what i want. I have BC11, what patch will i use.

 

[fcpli]

Try 96737. Note that if using RVA, the MSG number has to be 3 and VARI in TLP11 xxxxxxx0!