Right now we have a 2000 IPS and a voip system using cisco 2921 gateway. We have a tie line between the two systems so we can do interoffice extension to extension dialing. My question is this. If I send the 2000IPS an outbound call can I get the NEC to route the call out the T1s on the NEC. Can I send it 9+number or trunk access code +number to route out the NEC lines. Want to do this for when T1s go down on voip system. I know from the NEC I can have users just dial a access code to route calls to the voip system t1 but can I route inbound calls to NEC out the NEC t1s according to digits received by NEC.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Call Routing between VOIP Gateway and 2000 IPS
- Thread starter parkland
- Start date
OzzieGeorge
Programmer
The short answer is yes, the long answer is.... you are getting into a complicated area of the programming of an IPS.
Might I suggest you have a look at the FAQ here....
It gives you an idea of how LCR works as that is how you would have to deal with it!
Might I suggest you have a look at the FAQ here....
It gives you an idea of how LCR works as that is how you would have to deal with it!
- Status
Similar threads
- Locked
- Question
