I've come across some USRobotics power supply, they are 9VAC 1A and seem to plug into couple old CP 100 I have. My questions is will it work and or will they over heat with time? I've yet to try to boot them up but was wondering if anyone have used the higher Amps?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
call pilot power supply 9V 1A AC vs 600 MA
- Thread starter Sam173
- Start date
misseditbythatmuch
Technical User
The currently recommended power supply is 8 volts.
The CallPilot only draws the amps that it needs, but 9V will burn up the power circuit over time. As already mentioned the recommended voltage is 8VDC.
You also wrote that the US Robotics power supply is 9VAC. This won't work with a CallPilot as the output should be DC, not AC.
Brian Cox
Georgia Telephone
You also wrote that the US Robotics power supply is 9VAC. This won't work with a CallPilot as the output should be DC, not AC.
Brian Cox
Georgia Telephone
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
