Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Call Pilot Key codes 2

Status
Not open for further replies.

M1north

IS-IT--Management
Sep 28, 2007
357
CA
Where can I find the key codes when I log into the CP manager? Cant seem to locate them...

Thx
 
Launch on the server start->programs->callpilot->???->system monitor

This will give you all the information about your server. Ports, DSPs, keycodes etc.

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.
 
Can this be done by loggin in remotely or do I have to be on the server card direct?
 
It can be done remotely but you have to be logged into windows either via remote desktop or pcanywhere

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.
 
M1north...you can also do remotely and login to callpilot
manager then go to configuration wizard once you get to
your keycodes cancel out that way no changes has been made
an you good to go.

no problems only solutions

strmwalker
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top