Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Call Pilot 3 digit Mailboxes

Status
Not open for further replies.

srcvh1

Technical User
Feb 1, 2007
156
US
Hey All,
Got another doozy here. This will either be something stupid I've overlooked, or I'll have everyone scratching thier heads! Heres the scenario.

I have a 201i that crashed. Replaced the drive, reimaged, config wiz, load patches. Server comes up fine and able to except calls. I had no backup so I have to build all of boxes and SDN tables. The PBX has 3 digit extensions. I build my SDNs with three digits no problem, however when I try building a 3 digit mailbox I get a pop up that says it has to be between 4-18 digits long. No problem I think. I just went to the messaging tab, to messaging management and adjust the fixed digits to 3 from 4. No such luck, I get the same pop up! I go back into the messaging tab and adjust it to variable, once again no luck. This would seem to be very simple and work with either of these options. Any ideas on what I may be missing?
 
check your mailbox password length and make sure it matches the mailbox length.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top