Is there a way to find out the CallPilot ip without using hyperterminal? I recently took over servicing a system with a callpilot 2.0, and the ip address has been changed with no documentation left of it. I am trying to log in via hyperterminal, but I get nothing. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Call Pilot 100 IP Address Change
- Thread starter rval80
- Start date
curlycord
Programmer
No
Try this:
·Connect one end of Straight Through DB9 serial cable to laptop, connect DB25 to com port on Startalk Flash.
·On laptop add new HyperTerminal connection (start > accessories > Communications >HyperTerminal)
·Choose “direct to com” and Settings:1200 baud, 8 data bits, 1 stop bit , no parity.
Then reboot the CP and watch the action.
=----(((((((((()----=
curlycord
Try this:
·Connect one end of Straight Through DB9 serial cable to laptop, connect DB25 to com port on Startalk Flash.
·On laptop add new HyperTerminal connection (start > accessories > Communications >HyperTerminal)
·Choose “direct to com” and Settings:1200 baud, 8 data bits, 1 stop bit , no parity.
Then reboot the CP and watch the action.
=----(((((((((()----=
curlycord
- Status
Similar threads
- Locked
- Question
- Locked
- Question