Call Pilot 100, Centrex, CCR Tree, External Transfer

[telgirl]

I have a Call Pilot 100, CCR Tree and would like to transfer externally from one of the paths using the same Centrex line. However, I have only been able to set it up so the call uses two lines. It has been suggested I use #+9+number, but I am unsure of the line, pool, route etc. Any assistance would be appreciated.

 

[jerryreeve]

Try this: on the CCR path:: XFER -> EXT -> ->pool 15 ->Phone "#532" plus 9 plus number to transfer to
logic is: pool 15 is out of range of pools (it dosent exist so system ignores it) # says dial special characters, 5 says insert a flash (seen as a # on the display), 3 says insert a pause, 2 says go back to inserting numbers)

JerryReeve
Communications Systems Int'l
com-sys.com

 

[telgirl]

Thanks, I will try this when I am back on site. I will let you know.