Call from site A to site B's Hunt Group 2

[curlycord]

2 questions in bold to make sure I am still with it....

Site A - BCM 3.6 - DN range 5000
Site B - BCM 3.7 - DN range 8000 (sets are 80XX)
Currently already have Voip trunks to Intercom each other and working fine.

Job scope: To transfer calls from Site A to Site B - Hunt Group X8314.

I am doing remotely and unable to test as they are closed and presume MCDN key code required to dial site B from AA at site A correct?.

This is what I have done so far and wondering if I missed anything:


Site A –
Created Dest Code 83 and absorb 0, use same route as current one (Dest 80 using Route 00X/Pool 0)

Site B –
Created Target 390 with Private Received digits as 8314
Assigned 390 under HG003 programming




=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[curlycord]

....reception states "No Route To Destination" this morning.
The pipe is ok because they can call 80XX DN's with no issues.

All I did again was setup Dest 83 and copied from 80 (Absorb 0) and told it to use the same route that 80 uses.




=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[curlycord]

I changed HG DN from 83XX to 80XX and works fine.
Rusty on my routes.....would like to know still how to get 83XX to work.

=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[norstarboy125]

I would think that 8 any or 8A would route the call just fine.

Charm City Communications

http://www.charmcitycommunications.com

 

[curlycord]

There is no 8, only 80
80 route will not pass 83XX, only 80XX which makes sense?
That's why I tried to do a Dest of 83 to pass 83XX.


=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[curlycord]

or is it that even thought the dest code is 80 with asorb 0 it should still pass 83XX ?
I was thinking adsorb takes place after the 80.

Been to long.




=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[norstarboy125]

I get it, that's how the tech programmed it. I tend to go with the dest and any method. The good part is that you got the problem resolved.

Charm City Communications

http://www.charmcitycommunications.com

 

[SupportDude]

Curly,
You probably need to add 83 as destination digits on your VoIP gateway.
The Des Code only tells the call which route to use and how much of the des code to send to the route.
When the route is IP trunks, the gateway has to look at the digits to resolve them to an IP address.



-SD-

http://www.mysupportguy.net

 

[curlycord]

That rings a bell!

Thanks.

=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca