Call Forward at HiPath 4000

[RICHTz]

from analog station to make call forwarding

press wabe access code+number+#

i need to make the same process without press the final # from analog station.

also before from digital staion (openstage)

press wabe access code+number+OK

suddenly this OK is changed to press # to complete the process how can i retrive back to press OK at the final.

Thanks all

 

[sbcsu]

The OK should still work at a Digital Station.
On the Analogue you do press #

Make up a document and give it to your end users to show them?

 

[RICHTz]

hi sbcsu, you are agreat helper but,

on digital station it work now with # before with OK, i don;t know whats happened?

on analog always i do it by end with # but on one client i see it he make forward without press # so i need to know how?

Thanks alot

 

[sbcsu]

It will only work on the Digital with OK if the phone is setup correctly as a DIGNODIS=N in sbcsu
Also make sure ALL codes are entered in WABE even ones you dont use, for example

ADD-WABE:**9001,,,FWDIGNOR,N;
ADD-WABE:**9002,,,whatever,n;


etc...

Then the Optiset can use all features.

 

[sbcsu]

Just to clarify that.

It is possible that your system might not have all possible functions added in WABE.

Go to Comwin.
Click on MACRO/Retreive system variant...

Then Type ADD-WABE and then right mouse click on the ADD-WABE and use 'MML-Editor'
In there you can add all of the functions of WABE except the obvious ones like STN and so on by adding in a code for example
**9001 onwards...

Hope That Helps....

 

[RICHTz]

Thax alot for your help but regardin this parameter DIGNODIS=N its ok did it for al digital station,

also regarding definition for wabe codes its also right because before it work probably but somthing happened caused this error and as told you before for analog station i see it at one client do it without end by #.

Thanks for your cooperation.

BR
Modo

 

[sbcsu]

It depends on the HiPath version, if your system was recently upgraded then you would have to press OK or # at the end of dialling the forwarding.
It also might be that the code that you are forwarding to is variable in length.
You will need to find more examples of where it is not working and where it is working?