Call Divert to Mobile for non UCCM User

[kiNNik]

Hi,

I have a requirement for a DDI number to be on permanent divert to a mobile. The user does not have a account on the call manager, nor does he need one. I just need to provide a Land-line number so it can divert to his mobile. What is the best way for me to achieve this with the lease amount of aggro please. Should I use a route pattern or something ? or can this be done on the router ?
We have Call manager 7.1.2 and our Voice Gateway is a Cisco 2811.
Any ideas / help will be much appreciated.

 

[whykap]

create a CTI route point with a DN of xxxx which your DDI will point to and forward it always to the cell phone.

 

[kiNNik]

Hi, Thanks for that. Hoe do I point the DN at the DDI please ?

 

[whykap]

use a translation pattern to point the DID to the CTI route point.

 

[OzzieGeorge]

Ok so I'm just learning cisco voice and have only just started at that, but wouldn't it be easier to create a dial peer that strips the incoming number and substitutes the line access code followed by the mobile number? Isn't there a command that can actually do this for you (I can't immediately remember it but I used it to make operator calls go to the extension I wanted)? Are there advantages to doing it the way you describe

Sorry to intrude but as I say I'm trying to learn!

 

[Silverblade]

Why create a CTI route point? Translate the incomming number to the mobile number on the translation pattern i would say

 

[whykap]

I agree with silverblade. A translation pattern would be all you need.