Call connects but no voice cs1000 with NGN MSAG

[LittleMaster]

CS1000 RLS 4.5.
connected with ZTE MSAG through PRI.
DSCs are created at cs1000 side for MSAG extensions..
When user calls from MSAG side to cs1000 user, ring, voice every thing works fine. But when a cs1000 user calls to MSAG user, problem of no voice raised , sometimes there is complete silence, sometimes the call is connected and conversation is done between the users.
Summary of problem:: intermittent call connectivity ,voice hearing problem when usercs1000 user calls MSAG user.


THANKS

 

[Firebird Scrambler]

Is this a problem that's just started happening or is it a new configuration?.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.net

linkedin

 

[LittleMaster]

Greetings Firebird Scrambler, its great to see you..
Sir the problem has just started happening. Everything was going good. I have checked the routes, deleted the tie trunks and recreated, had a restart to the cs1000, however, it didn't work.

 

[Firebird Scrambler]

How many trunks exist on the PRI card?. Is the route set to RRB or LIN ?.

It could be that the CS1000 is using the last trunk member first on outgoing calls if "LIN" is set and you need to find out how many trunks exist on the ZTE MSAG end.

Also stat the PRI link in LD 60 such as "STAT 2" etc if the PRI card is in Slot 2 on the CS1000.

Are you using a 24 or 30 port PRI card?.

Try changing the RDB to RRB so thar a different trunk is selected each time on outgoing calls.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.net

linkedin