Hi,
I had some problems configuring a P334T Cajun Switch. I made a mistake and I run command "set interface <vlan> <ip> <mask>" and put the vlan id as 2. The result is that I could not connect the switch more. So I tried to force the reset (pressing at the same time the two menu buttons and the FIV switch, releasing the buttons and after 2 seconds a realesed the FIV) as recomended on the manual. But I still couldn't connect the switch so the initial defaults were not loaded. Some one knows how to force the reset on the right way ? If the only way to do fix the problem is to connect it using the console, how do I can make a DB9 - RJ45 serial cable ? I don´t have one...
I had some problems configuring a P334T Cajun Switch. I made a mistake and I run command "set interface <vlan> <ip> <mask>" and put the vlan id as 2. The result is that I could not connect the switch more. So I tried to force the reset (pressing at the same time the two menu buttons and the FIV switch, releasing the buttons and after 2 seconds a realesed the FIV) as recomended on the manual. But I still couldn't connect the switch so the initial defaults were not loaded. Some one knows how to force the reset on the right way ? If the only way to do fix the problem is to connect it using the console, how do I can make a DB9 - RJ45 serial cable ? I don´t have one...