Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

C2690X-24PS-L question

Status
Not open for further replies.
rn4it

rn4it

MIS
Joined
Nov 7, 2002
Messages
671
Location
CA
Hi
I'm just wondering about some power requirements for our new switches. we received 6 they had a mix of power cables both 3 prong and twist lock. These switches will be used to power IP phones and Access Points. What my question is at what point would I need to use the twist locks for 240volts? or would the standard 3 prong for 110volt power be sufficient?

Thanks
John
 
Status
Not open for further replies.

Similar threads

Zero6
  • Locked
  • Question Question
question about cisco cbs 350-12xs 12 port 10g sfp+
Replies
0
Views
509
Zero6
Zero6
woza
  • Locked
  • Question Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
753
DrB0b
DrB0b
stanlyn
  • Locked
  • Question Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
654
iggsterman
iggsterman
Mogles49
  • Locked
  • Question Question
Firewall ACL question
Replies
1
Views
358
burtsbees
burtsbees
Gartech
  • Locked
  • Question Question
LAN Port Test Device
Replies
3
Views
477
ipohead
ipohead

Part and Inventory Search

Sponsor

Back
Top