aphonechik
MIS
Just wondering if anyone knows of a busy signal analysis report that I can run within Site Administrator.
Thanks,
Fit
Thanks,
Fit
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Busy signal analysis
- Thread starter aphonechik
- Start date
- Status
wildcard100001
Technical User
You could run the following command:
list measurements trunk-group summary yesterday-peak
On the second to the last column the %ATB means percent all trunks busy.... which would translate into a busy signal to the caller... this report would give you yesterdays peak....
As a dirty historical method, you could use ASA to run this report a few minutes past every hour to get data on a whole day...
On the other hand if you had CMS and trunks measured and defined, that would be easier. Run a historical report on the trunk.
Lastly, if the trunk only handles toll free numbers... the carrier of the toll free nubmer would be able to tell you how many busy signals were presented when called.
Thanks,
Wildcard
list measurements trunk-group summary yesterday-peak
On the second to the last column the %ATB means percent all trunks busy.... which would translate into a busy signal to the caller... this report would give you yesterdays peak....
As a dirty historical method, you could use ASA to run this report a few minutes past every hour to get data on a whole day...
On the other hand if you had CMS and trunks measured and defined, that would be easier. Run a historical report on the trunk.
Lastly, if the trunk only handles toll free numbers... the carrier of the toll free nubmer would be able to tell you how many busy signals were presented when called.
Thanks,
Wildcard
- Status
Similar threads
- Locked
- Question
