Building a Option 11C

[89549]

Hello,

I am trying to build a Option 11C to retrain myself on this switch(looking for a better job). I have been working for a telecommunications company but all we work on
are the smaller key systems and The last time I went to Nortel training was back in 1997 and trained on release 23. My memory has faded so any help from you would be greatly appreciated.
What I have so far is a new Option 11 cabinet, NTDK78AA, SSC-NTDK20DA with a NTDK81AA daughter board and security device mounted on it, a NT8D02AB and a NT8D14AH.
Would I be able to use the system as I have it here? Is the SSC card missing anything (software?) or is it build in? Can I default the system to the factory password settings? Any additional information would be appreciated?
Thanks Tony J

 

[acewarlock]

Didn't you ask these same questions on pbxinfo.com?
Did you do the things they suggested?
have you tried turning the switch on?

 

[89549]

Yep I sure did. I am still trying to get into the switch. The questions I'm asking here were not answered on the other site. Maybe someone here can answer the questions posted. Thanks

 

[acewarlock]

Did you turn on the switch?
Did it boot up?

 

[89549]

Hello,

The switch comes on. The station card works, the trunk card has a red light on it. When you pick up the hand set you hear system dial tone but the phone on the display ask what type of phone (20)?. I cannot log into the system. I've tried 0000, nortel, do you know of any other default passwords that I can use to reset the password in LD 17?

Thanks TJ

 

[acewarlock]

Sorry I don't

 

[john807]

You need the password, Nortel can recover it for you or you can try to locate a company with an engineer to do it. It is not easy or cheap.

John 807

 

[89549]

Thanks John,

The little security dongle on the card, if you reset it do anything? Where actually is the password stored?

Thanks TJ

 

[acewarlock]

Question about Passwords are not allowed to be answered here.