evilmonkfish
Technical User
Hi I was wondering if anyone could help me with this?
I have two sites running BSR these have been working fine for some time over traditional TDM trunks.
I have just setup 2 x h323 trunks which worked fine in testing and seem to be working fine in live except i am seeing the following in the events
BSR: TSC trk mbr not adm
I think this is refering to the fact that on the trunk form I have not assigned a trunk member to "NCA-TSC Trunk Member", I have tried assigning 1 but when I do this the call connects but I cant hear the agent nor can they hear me.
Any Idea's?
Below is the config for the trunk
Group Number: 890 Group Type: isdn CDR Reports: y
Group Name: PB to BUR IP T1 (Tesco) COR: 1 TN: 2 TAC: 890
Direction: two-way Outgoing Display? n Carrier Medium: H.323
Dial Access? y Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: auto
Signaling Group: 649
Number of Members: 100
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: b Digit Handling (in/out): enbloc/enbloc
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
CONNECT Reliable When Call Leaves ISDN? n
TRUNK FEATURES
ACA Assignment? n Measured: both
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Hop Dgt? n Send EMU Visitor CPN? y
Suppress # Outpulsing? n Format: public
UUI IE Treatment: shared
Maximum Size of UUI IE Contents: 128
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: n
Hold/Unhold Notifications? y
Send UUI IE? y Modify Tandem Calling Number? n
Send UCID? n BSR Reply-best DISC Cause Value: 31
Send Codeset 6/7 LAI IE? y
TSC Method for Auto Callback: drop-if-possible
Diversion by Reroute? y
Path Replacement? y
Path Replacement with Retention? n
Path Replacement Method: better-route
SBS? n
Display Forwarding Party Name? y
Character Set for QSIG Name: eurofont
QSIG Value-Added? n
display signaling-group 649
SIGNALING GROUP
Group Number: 649 Group Type: h.323
Remote Office? n Max number of NCA TSC: 10
SBS? n Max number of CA TSC: 10
IP Video? n Trunk Group for NCA TSC: 890
Trunk Group for Channel Selection: 890
TSC Supplementary Service Protocol: b Network Call Transfer? n
T303 Timer(sec): 10
H.245 DTMF Signal Tone Duration(msec):
Near-end Node Name: prbclan-09b10 Far-end Node Name: burclan-06a10
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 1
LRQ Required? n Calls Share IP Signaling Connection? y
RRQ Required? n
Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: in-band Direct IP-IP Audio Connections? y
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? y
Enable Layer 3 Test? y Interworking Message: PROGress
H.323 Station Outgoing Direct Media? n DCP/Analog Bearer Capability: 3.1kHz
I have two sites running BSR these have been working fine for some time over traditional TDM trunks.
I have just setup 2 x h323 trunks which worked fine in testing and seem to be working fine in live except i am seeing the following in the events
BSR: TSC trk mbr not adm
I think this is refering to the fact that on the trunk form I have not assigned a trunk member to "NCA-TSC Trunk Member", I have tried assigning 1 but when I do this the call connects but I cant hear the agent nor can they hear me.
Any Idea's?
Below is the config for the trunk
Group Number: 890 Group Type: isdn CDR Reports: y
Group Name: PB to BUR IP T1 (Tesco) COR: 1 TN: 2 TAC: 890
Direction: two-way Outgoing Display? n Carrier Medium: H.323
Dial Access? y Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: auto
Signaling Group: 649
Number of Members: 100
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: b Digit Handling (in/out): enbloc/enbloc
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
CONNECT Reliable When Call Leaves ISDN? n
TRUNK FEATURES
ACA Assignment? n Measured: both
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Hop Dgt? n Send EMU Visitor CPN? y
Suppress # Outpulsing? n Format: public
UUI IE Treatment: shared
Maximum Size of UUI IE Contents: 128
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: n
Hold/Unhold Notifications? y
Send UUI IE? y Modify Tandem Calling Number? n
Send UCID? n BSR Reply-best DISC Cause Value: 31
Send Codeset 6/7 LAI IE? y
TSC Method for Auto Callback: drop-if-possible
Diversion by Reroute? y
Path Replacement? y
Path Replacement with Retention? n
Path Replacement Method: better-route
SBS? n
Display Forwarding Party Name? y
Character Set for QSIG Name: eurofont
QSIG Value-Added? n
display signaling-group 649
SIGNALING GROUP
Group Number: 649 Group Type: h.323
Remote Office? n Max number of NCA TSC: 10
SBS? n Max number of CA TSC: 10
IP Video? n Trunk Group for NCA TSC: 890
Trunk Group for Channel Selection: 890
TSC Supplementary Service Protocol: b Network Call Transfer? n
T303 Timer(sec): 10
H.245 DTMF Signal Tone Duration(msec):
Near-end Node Name: prbclan-09b10 Far-end Node Name: burclan-06a10
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 1
LRQ Required? n Calls Share IP Signaling Connection? y
RRQ Required? n
Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: in-band Direct IP-IP Audio Connections? y
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? y
Enable Layer 3 Test? y Interworking Message: PROGress
H.323 Station Outgoing Direct Media? n DCP/Analog Bearer Capability: 3.1kHz