Hi all,
I am getting a BSOD shown below while attempting to start a vhd on hyper-v. it was working perfectly fine a couple of days ago but now it has started showing this same BSOD everytime i try to start it. the vm is server2003r2 and host machine is server2008r2. There are 3 other VMs running fine on the same hyper-v manager except this one.
"A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:
Check for viruses on your computer. Remove any newly installed hard drive or hard drive controllers. Check your hard drive to make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.
Technical information:
*** STOP: 0x0000007B (0xF789EA94,0xC0000034,0x00000000,0x00000000)
Its vhd is already set with IDE controller. There are 3 network adaptors connected to all VMs.
I am open to try anything to solve this issue. Therefore, please help me with any idea you may have to make this VM running.
Regards
manibest
I am getting a BSOD shown below while attempting to start a vhd on hyper-v. it was working perfectly fine a couple of days ago but now it has started showing this same BSOD everytime i try to start it. the vm is server2003r2 and host machine is server2008r2. There are 3 other VMs running fine on the same hyper-v manager except this one.
"A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:
Check for viruses on your computer. Remove any newly installed hard drive or hard drive controllers. Check your hard drive to make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.
Technical information:
*** STOP: 0x0000007B (0xF789EA94,0xC0000034,0x00000000,0x00000000)
Its vhd is already set with IDE controller. There are 3 network adaptors connected to all VMs.
I am open to try anything to solve this issue. Therefore, please help me with any idea you may have to make this VM running.
Regards
manibest