BSD 090 question for freddog or anyone else

[viper222]

In a post a year ago named "BSD 090 Errror" and that is how Error was spelled, there was a discussion about BSD 090s caused by remote fiber cabinets. freddog's situation was with and Option 61 and remote 11 cabinets. I have an Option 81 with two remote 11 cabinets. When I log out and the switch goes into backgrounds it runs LD45. This then shows a BSD000 and BSD090 then it starts out with testing. It produces the same output as when you do a TEST under LD45. I read where you should let it run at least twice then do a CMAJ in LD30 but that does not resolve the issue. My OVLY in LD17 does not have 45 in it. I cannot find anything that is causing it to constantly, and I do mean constantly, do this. If freddog is reading, is this the same thing your switch did, for anyone else, have you experienced this. Thank you ahead of time.

 

[ArchTelecom]

You sure you do not have a power or power monitor related problem causing this error? Just somethng to check if you haven't already.

Also, under your OVLY, make sure you are looking at the "BKGD" area under your ovly.

 

[viper222]

Positive I don't have a power issue, no. I have no minor or major alarms and my voltages on the QBL input and output look good. How would I narrow down what type of power problem if that is it?