Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bridging with Max 6000

Status
Not open for further replies.
OW132

OW132

ISP
Nov 25, 2002
2
EC
I am running a MAX 6000 with firmware release eik.m60 9.0.3 and I cannot get the bridging parameter to do anything but say N/A. How do I active bridging in the MAX?
 
Sort by date Sort by votes
Goto Ethernet > Mod Config. Make sure Bridging=Yes. You may also have to goto Ethernet > Answer > PPP options. Set Bridge=Yes here as well.

Hope that answers your question.
 
Upvote 0 Downvote
I review this options, buy all say N/A

Ethernet --> Mod Config ---> Bridging=N/A

Ethernet --> Answer ---> PPP Options ---> Bridge=N/A

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

UnderTheBusAsUsual
  • Question
Avaya IPO with OneCom and Gamma SIP trunks
Replies
1
Views
316
Firebird Scrambler
Firebird Scrambler
Tre0307
  • Locked
  • Question
Need help with Upgrade recommendations
Replies
1
Views
252
Westi
Westi
Elanaclearcom
  • Locked
  • Question
Can't communicate with switch
Replies
1
Views
192
Westi
Westi
AlfonsoSF
  • Locked
  • Question
how to configure a port with two or more vlans
Replies
0
Views
198
AlfonsoSF
AlfonsoSF
Iniesta
  • Locked
  • Question
Connect 61C with Cisco router with Tie
Replies
0
Views
75
Iniesta
Iniesta

Part and Inventory Search

Sponsor

Back
Top