NickCheung
Technical User
Dear,
I want to bridge traffic from a 2501 (one ethernet port) to a riverstone router over 2 T1. Is the command "bridge-group xxx circuit-group xxx" Cisco proprietary?
As I know I can¡¦t config same bridge group for two serial interfaces. This will cause looping. How can I use both T1 to convey the traffic between two different routers?
Many Thanks
Nick :
I want to bridge traffic from a 2501 (one ethernet port) to a riverstone router over 2 T1. Is the command "bridge-group xxx circuit-group xxx" Cisco proprietary?
As I know I can¡¦t config same bridge group for two serial interfaces. This will cause looping. How can I use both T1 to convey the traffic between two different routers?
Many Thanks
Nick :