Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bridged Appearance Rings- Original Ext Does Not

Status
Not open for further replies.

medeamedea

Technical User
Oct 11, 2007
61
US
I have 2 6408D+ stations (G3i V9.5), one is bridged on the other. The bridged appearance rings audibly, the original phone blinks but no audible ring. Why is this??

Config is thus:

FEATURE OPTIONS
LWC Reception: msa-spe
Auto Select Any Idle Appearance? n
LWC Activation? y
Coverage Msg Retrieval? y
LWC Log External Calls? n
Auto Answer: none
CDR Privacy? n
Data Restriction? n
Redirect Notification? y
Idle Appearance Preference? n
Per Button Ring Control? y
Bridged Call Alerting? y
Restrict Last Appearance? y
Active Station Ringing: continuous


H.320 Conversion? n
Per Station CPN - Send Calling Number?
Service Link Mode: as-needed
Multimedia Mode: basic
MWI Served User Type:
Display Client Redirection? n

Select Last Used Appearance? n

Coverage After Forwarding? s


Direct IP-IP Audio Connections? y

IP Audio Hairpinning? y


Thanks!!
 
I noticed you have per button ring control turned on. Make sure that on the original phone where your call-appearances are programmed that you have an r for ring programmed for each appearance.
 
Also check if the station has a ringer-off feature button that may be active.
 
I think it may have been 'operator error', I just went out there and all rings well. Thank you!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top