Brand new PRI loop 1

[telepath]

Hello everyone,
I have modified and reused a couple of PRI links in my CS1000M v5.5, but I now have to make a new one almost from scratch. I have a working PRI link in a dual Pri card and I want to use the other side (never been used).
I'm following Mike´s Cookbook, but at step 1 (I'm familiar with almost all the next steps) it shows the first error. This is what I have done:
I looked for a free loop at LD22 cequ
XCT 002 016 032 048
064 080 096 112

CONF * 003 * 017 * 033 * 049
* 065 * 081 * 097 * 113
MFSD * 002 * 016 * 032 * 048
* 064 * 080 * 096 * 112
PRI2 001 014 015 034
035 076 077 098
099 126

I chose 70 because it's unlisted and I want it to match the Dchannel and the route (soon to be created as 70 too), the loop in the same card, left side is 126 but I don't know if i have to choose 127 as the loop since, as You can see, all my other working loops follow that scheme.
The error I get is as follows:

LD 17
REQ chg
TYPE cequ
.....
PRI2 70
SCH0535 ***Attempted to remove non-existing loop or add existing loop.***
Severity: Info



Thanks in advance.

 

[KCFLHRC]

What is the loop on the first port of that card? If the existing loop is 34 then the new loop will be 35. You just cant make up loop assignments, they have to match the hardware in an 81

 

[telepath]

IC, that was my guess (as I posted ). The other side is 126 so i'll use 127, and create dch and route as 127 aswell.
Thank You.