BP250 2B+D

[wahacom]

Hi All
I have problem with connection ( Q-Interface ) between two BP250 ( MFU ), All trunks gives me blocked.
The programming two sids is:

(Master)

1910 Q-Interface
1911 ETSI/ECMA
1912 Master ( layer 1 master )
1947 Handling of call collision: side A
1922 Through connect after SETUP to network
: Not checked
1921 ignore in band information: checked
1940 UUS service 1,2 and 3 requested
1943 UU information in alertmessage:
checked

1949 UUI

(Slave)

1910 Q-Interface
1911 ETSI/ECMA
1912 Slave
1947 Handling of call collision: side A
1922 Through connect after SETUP to network
: Not checked
1921 ignore in band information: checked
1940 UUS service 1,2 and 3 requested
1943 UU information in alertmessage:
checked
1949 UUI


plz hlp me.

Regards

 

[slash50]

What other options do you get for "1947 Handling of call collision"?

I don't know much about BP250 at all, but should one of these be Side A and the other be Side B?

 

[bpczi]

Hi!

Which Release of BPH do you have? Do you have licenses for qsig? Have you checked the dip-swith settings on mfu? What says the link supervisor?
How are these 2 BPH`s connected togehter? Is there a router or such device between them?

best regards

bpczi