BP 128/250: no busy tone at "busy" at extension, second call get free line signal

[nitram11]

Hello, all,

have a problem with programming in a bp 128; have unchecked system cmd 2080 in bms ( free on 2 line) , but get a free line tone, not a busy tone, when a second call comes to "busy" extensions; is there something more
to do in the trunks ?;
thanks a lot for all hints.

 

[zoo1]

Check if you have Open/Close 2nd line key programmed on the phone - if not, try to program and acivate/deactivate...make any difference?

 

[nitram11]

Hello, zoo1
first thank you for your reply; have checked , if a key was programmed(was not) and also have programming a phonekey "free/busy on second line" ; activate/deaktivate makes no difference for incommming second calls; getting free line tone..
what is working correct. is, that led for second line does not go on, when second call comes in;

i have compared with annother programming , which i made long time ago in a bp 250, i only remember and find cmd 2080 for setting this ....?

i am wondering , if this may be influenced by new kind of trunks here (voip trunk instead of isdn)

any idear more ?
thanks a lot.

 

[zoo1]

Same as you...only 2080 control this...have you tried internally?

 

[xs650]

-check camp on allowd at the extension
-if you call the reroute position via -0 you never get a busy tone

 

[nitram11]

...camp on isn´t allowed...have to made some more combinations intern-extern , might be, that it has to do with no operator extension in this system..?

thank you both very much for this help, xs 650 + zoo1 !