Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bogen PCMSYS3 with a Viking CTG-2A

Status
Not open for further replies.

qthephoneman

Vendor
Jul 11, 2019
8
US
I have an Avaya IPO paging through a PCMSYS3 and a Bogen amp and its working great. I installed a CTG2A and I can hear the trigger tone out of the audio out on my butt set. I connected the audio out to the BGM in and rt on the PCMTIM and enabled code 019. Bogen says that will send the tone over all zones but I get nothing. Now Bogen is not answering. I NEED HELP PLEASE!!!!
 
Configuration 14 on page 30 of this manual

Looks like you got it connected and programmed properly, ensure the BGM volume is up on the PCM TIM, does your amplifier need any kind of contact closure to keep paging open?

Try your toner on the BGM input, see if it comes out

Maybe connect to the Override jack on the PCM TIM using the Page Trigger contacts on the Viking to enable, so that pages won't interrupt clock tones
 
Make sure the Global BMG shorting pins are set right on the ZPM modules.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top