BMS map as a POP-UP

[paskual]

Hello!

I need to send a pop-up in de middle of BMS map.
The problem is: if I send a small BMS map after a big BMS map, the lines without variables are full of the variables of the previous map.

I am paying with the parameters of the map and the intruction SEND MAP and I haven't got luck.

Could someone help me?

Thank you very much

 

[zSoftware]

Refer to the old CICS/ESA V4R1 Sample Applications Guide.

(CICS 2.2 documentation still links to this below).

http://publibz.boulder.ibm.com/cgi-...02/CCONTENTS?SHELF=DFHPUSHD&DT=20000119160324

From there quickly read the chapter entitled "BMS and CUA user dialogs", specifically Pull-downs and pop-ups.

In there follow the link to 2.4.3.1 Pull-down and pop-up techniques using BMS

I am going to assume you are using an Overlay technique, so the Overlay map paragraph should provide you with some insight.

Hope this helps to point you in the right direction.

zSoftware