Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Blocking programing name key by user 2
- Thread starter jarmac
- Start date
-
1
- #2
Enable Write Protection when you add the NAME key.
<add-ziel
TYPE = name
SRCNO = 8180
KYNO = 14
DESTNON = 2525
DEV =
LEVEL =
PROTECT = ?
PROTECT : CP WRITE PROTECTION FOR NAME KEY
CHARACTERISTIC : OPTIONAL
POSS. VALUES : YES YES
NO NO
LoPath
Maintain HiPath 4000 V5 & V6, OpenScape Xpert V4, Xpressions, Contact Center
<add-ziel
TYPE = name
SRCNO = 8180
KYNO = 14
DESTNON = 2525
DEV =
LEVEL =
PROTECT = ?
PROTECT : CP WRITE PROTECTION FOR NAME KEY
CHARACTERISTIC : OPTIONAL
POSS. VALUES : YES YES
NO NO
LoPath
Maintain HiPath 4000 V5 & V6, OpenScape Xpert V4, Xpressions, Contact Center
- Thread starter
- #3
-
1
- #4
If you are using assistant it is in where you view the standard key table on the Basic 1 tab. When you click on the key to program the button there is a check box for Protect. Now the thread shows both ways to do it 
)
Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA
)Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA
- Status