Blocking calls based on caller ID

[dwats9]

Hi guys,

Is there any way I can block an incoming call based on its caller ID in system programming?

Thanks

 

[curlycord]

Use the Caller ID table in Callpilot.
You can input the number then tell it where to go.
i.e. disconnect, path, info etc

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[Firebird Scrambler]

This can be used for the annoying PPI calls that we get in the UK.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[dwats9]

Thanks guys!!

 

[curlycord]

I forgot to mention....Callpilot has to answer the call, not a human and it also needs to be told to answer after 2 rings if using standard POTs lines since the carrier send caller ID signal between 1st and 2nd rings.



=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[dibthree]

Any way to accomplish the same if a Human is answering?

 

[curlycord]

Please read my post above "not a human"

=----(((((((((()----=
curlycord

http://www.curlycord.com