Blinking "User: <dn>" on IP phones connected through BCM50 redirected to CS1000

[bosox1256]

Hello:

I had posted this over at the BCM forum, and was told to post it here.

I currently have a multi-site setup with a mixture of digital and IP phones. At 2 of our remote sites, I have Nortel 2004p2 phones and 1230 phones connected through a BCM50 that are re-directed to the CS1000 at our main site.

For a while now, since we had our signaling server rebuilt (due to corruption), the phones at the 2 remote BCM50 locations have a message on then that says "User: xxx" (xxx being the DN number) and it just blinks on and off. Is there a way to turn that off? Running 6.0.

NOTE: I work at the main site and just started a 1230 IP phone at my location, and my phone does not do this. Figure there must be some kind of setting to turn this off.

Thank you!

 

[Tman45]

The UserDN or DID) will display on any phones registered to the remote site (that is kind of a 'nice' indicator to know)
This would be why your main site phones don't show it.
I did read there is a patch to remove it (as some were complaining about it).

Sorry I don't have it handy what patch it is ...