BLF for analog line

[T8keiteasy]

Hi,

Using 3300 Cxi, I have two analog lines (#10 and 11) on AMB.

I would like to supervise those two lines from an IP set so when one is engaged, I could see it from the IP set.
BLF is normally used to supervise telephones, but is there a way to do the same for analog lines ?

Regards

Now, it's about French users too !!!

 

[Mitelpassion]

DSS buttons on the IP set for those extensions?
am sure that'll work for analogs too but I stand corrected here.

 

[T8keiteasy]

I've found a way : Using DTS in the analog trunk assigment. This is exclusive with the use of trunk group !!

When a number has been choosen for DTS service, it can be supervised on set (multicall, key system) as TXXXX; T means "trunk" and XXXX is the DTS service number. If DTS is 10, XXXX=0010.

BUT, this use, mean you won't use trunk group, so your trunk won't be taken by anyons using prefix...

Keep cool


Now, it's about French users too !!!

 

[kwbMitel]

Say What?

When you were saying analog line you were talking about Trunks?

This wasn't exactly clear.

MtelPassion's response assumed you meant Analog Station as I had assumed as well.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[T8keiteasy]

Yes kwbMitel, you're right
I was talking about analog trunk...it was a bad translation from French

Now, it's about French users too !!!

 

[Mitelpassion]

ah I see