Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blast Conference (Internal)

Gus1972

Vendor
May 27, 2016
12
US
Is there a way to add additional members to a blast conference (CM 10.2)? All analog extensions / all internal. Abrdg-appr does not fit the customer needs. I thought I could assign the group members of the conference as a Hotline. That has not worked either. Anyone have experience with this situation? Currently working fine with 8 members. Needs to work with 11.
 
can you not add the VDN of a second blast conference to the first blast conference? You would need a H323 loop around trunk but guessing you have something like this as the CM used to only do a max of 6 without one.

In the SA8893 document I have (attached) it was this bit that made me think that:

During dial-out of a Blast conference, if CM software's adding an automatically dialed destination to a Blast Conference would cause the total number of parties on the conference to be greater than 6, CM splits the call into two conferences, connected via a loop-around trunk. CM does not add a loop-around trunk if the number of parties is less than or equal to 6.
 

Attachments

  • SA8893_Blast_MeetMe_Conference.pdf
    528.2 KB · Views: 3
Last edited:

Part and Inventory Search

Sponsor

Back
Top