Blank Page at end of report when Using "New Page After"

[Cydamac]

In order to keep the correct formatting of one of my contracts, I must use the "New Page After" section formatting. This creates a problem for the last record in the report, as a blank page prints at the end of the report. Though the paper is not being prpinted on, the extra page seems unprofessional when my cleint runs the report. Is there any way to supress the last page of the report, as it is always going to be blank?

Thanks,

Carlos Jury

 

[mbarron]

Click the the (x-2) button next to the "New Page After" and and for the formaula use
"not onlastrecord" (no quotes of coure) Mike

 

[chelseatech]

The blank page at the end is the Report Footer. If youa re not using it then suppress that section. Editor and Publisher of Crystal Clear

http://www.chelseatech.co.nz/pubs.htm

 

[Cydamac]

Thanks for the help. I actually had to use the MAXIMUM Arithmetic Function because of where I had to put the "New Page After." I tried to supress ONLASTRECORD, but I did not work.

Thanks for the good ideas.