Blank Page after Report Header

[tmozer]

This seems to happen a lot with my reports (CR 8.5):

I get my report header with the rest of the page blank. Then the acutal data starts on page two. I think it happens when the Group listing spans more than one page....

Is there anyway to prevent this in 8.5? I have taken to skipping the Report Header and just use a Page Header. Not really what I wish to do.......

 

[lbass]

This could be caused by a number of things. If you are formatting the group header section with "new page before", you need to add the following to the formula section:

not onfirstrecord

Otherwise, this might be the result of checking "keep group together" when you set up your group. See what happens if you go to report->change group expert->options and uncheck "keep group together."

You might also make sure you are resizing the report header to the smallest size necessary for its contents.

-LB