Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BIJ 1200N

Status
Not open for further replies.
Michael52x

Michael52x

Technical User
Oct 4, 2005
813
US
Howdy all! My turn to ask a question.
This unit will not print down to the bottom margin.
It stop's 1-1/2 in. from a .05 margin.
Top and side margins are good.
Newest firmware. Good rollers and registration.
PQ is good, paper is set to letter.
Any ???Thanx, Michael

"Impatience will reward you with dissatisfaction" RMS Cosmics'97
 
Sort by date Sort by votes
All is good. Had another unit on shelf with a NIC problem that is now fixed, and no margin errors.Swapped.

"Impatience will reward you with dissatisfaction" RMS Cosmics'97
 
Upvote 0 Downvote
Do you still have the printer with the problem?

I know that in the older printers (as I'm sure you remember) there was a "lines per page" setting... if that was set to less than 66, then it would leave a larger margin....



Just my 2¢
-Cole's Law: Shredded cabbage

--Greg
 
Upvote 0 Downvote
Thanks gb, It would print to the .05 once, and then cut it off on next pages. All calibrations were good, and there was no paper advance issue. Printer was well worn out, and the formatter was the culprit.

"Impatience will reward you with dissatisfaction" RMS Cosmics'97
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top