Hey All, I'm running BE8.5 to a DDS4 120/240 Tape changer and have been running into problems with multiple jobs to a single tape. Essentially, I'll set the first job as an overwrite and then others to start in 15 minute increments there after as an append to tape with the final set to eject. After the first job completes, the next will grab another tape to append to leaving the first with only 1/20th of its media used. I never had this problem when using Arcserve and I desparately need to split jobs to monitor success and failure. I even tried erasing tapes before hand in order with no results. This is happening on 2 other similar systems. I'd appreciate any help.
Many Thanks,
geogh
Many Thanks,
geogh