Belkin bridge/repeater - configuring

[maslett]

Hi guys & gals, I have a Belkin wireless router in my kitchen (hard wired) and I have bought a bridge/repeater to extend the coverage. Problem is this...

The bridge/repeater manual says that to configure the device you use a browser poining at 192.168.2.1 (the routers IP address) and in the router set-up screen you will see an option called 'Wireless Bridge' which you select and then enter the mac address of the bridge/repeater. *But* I have no 'Wireless Bridge' option so I can't tell the router about the bridge/repeater (hence it doesn't work). I've checked all the options on the router set-up screen but to no-avail.

Any help greatly appreciated.

Ta,
Matt

 

[cdlvj]

look at upgrading the firmware for your device.

 

[maslett]

Just came back to say I'd found the answer on the Belkin websight (why didn't I look there first????)- was a firmware prob as cdlvj states above (cheers cdlvj)

Matt