Behaviors are attaching to multiple objects...

[Guest_imported]

Sorry if my terminology above isnt correct. Basically I have a presentation that has mutliple buttons on each screen. At the welcome screen the users can click to watch a tutorial or click to install software. This works fine. On the install software screen I made a button that launches the "QuickTime" installation using the on mouseup perform an open "quicktimeinstaller.exe" deal. This works, but for some reason its applying that same mouseup behavior to all the other buttons on the stage at that time. There is a "QuickTime already installed" button that sends the user to a different marker, but now all the buttons on the screen launch the quicktime install. Even the "install software" button from the previous screen launches it? I went and cleared ALL behaviors from all buttons on the stage and right-clicked and added the mouseup and open command and it immediately applied itself to many other objects. Any ideas? Im using the trial version as I wait for commercial to get here.

Thanx, Dave Weil
Software Engineer
Saint Alphonsus Regional Medical Center
Boise, Idaho

 

[Guest_imported]

Mr.Dave Well !!
your problem is small.Make sure the buttons
which are all taking same behaviour were dragged indidually
from cast window.If the button were copied sprites either
on stage or score window , probably it would have happened.
My suggession is you place each and every button seperately
from cast window to stage and then apply the behaviour.

Lokesh,
Multimedia Programmer,
Bangalore,india.
lokesh_ma_jmc@rediffmail.com