Hi,
I have a problem to resolve when sending faxes from our MD110 (BC10) connected with ISDN/PRI to the public network.
In certain call scenarios, we are unable to send faxes to analog extensions, connected to ISDN/BRI.
In order to make those phones ring, the ISDN (SETUP) message must have the BEARER CAPABILITY flags set to "3.1 KHz" rather than "SPEECH".
I have been successful in doing that with the analog extensions of my PBX, setting the proper category:
EXCAC
IR=xxxx,ICAT=1000;
Unfortunately I should do something similar also for the incoming IVR ports. Those ports/extensions are E1/CAS (EL7) ports and I don't know what setting to apply (the one for analog do not apply here).
Does anyone know?
Thanks
I have a problem to resolve when sending faxes from our MD110 (BC10) connected with ISDN/PRI to the public network.
In certain call scenarios, we are unable to send faxes to analog extensions, connected to ISDN/BRI.
In order to make those phones ring, the ISDN (SETUP) message must have the BEARER CAPABILITY flags set to "3.1 KHz" rather than "SPEECH".
I have been successful in doing that with the analog extensions of my PBX, setting the proper category:
EXCAC
IR=xxxx,ICAT=1000;Unfortunately I should do something similar also for the incoming IVR ports. Those ports/extensions are E1/CAS (EL7) ports and I don't know what setting to apply (the one for analog do not apply here).
Does anyone know?
Thanks
