BCM's PRI and Analog Ports being used for Fax. 1

[TWISTEDAPP]

If you have an analog port being used for a fax on a PRI is there anyway to get a busy condition when the fax is in use? The default 2 intercom paths seem to be in effect irrespective of whether you put one target line appearance or not. I've tried a little playing around with C.Fwd Busy in an effort to cheat the situation.

Does anyone have an answer or workaround?

 

[DBrewsky]

Ext XXXX> 1 Intercom Path
Target Line for FAX> Prime set on the target line to NONE
Ext XXXX> DND on Busy set to YES

This will give you busy tone if the fax is in use, whether it's an inbound or an outbound call.

 

[TWISTEDAPP]

Perfect! Thanks! I knew it had to be something simple.