Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM50R6 routing to external route

Status
Not open for further replies.

koulioumbis

IS-IT--Management
May 21, 2009
421
GR
Team Hello,
I have connected a BCM50R6 connected via SIP trunks to a SOFT SIP PBX.
I can make and receive calls via access code , can someone help with creating dialing plan rule to dial direct the extensions of the SOFT SIP PBX without the use of access code on BCM?
The users on the other side are 3XX , 2XX.

Thanks

Nikos
 
Problem:
1 - Your sites use the same DN's
2 - The client finds it difficult to dial a code for each site followed by the DN.

What DN range is the BCM site?

If it's 2XX you already have 2 issues.
1 - Two sites using the same lead digit in their DN
2 - "2" is in use on the BCM as an internal DN so you couldn't even use 2 as a Dest code

Have a look at this thread to see what you are up against.


"The client finds it difficult to dial a code for each site followed by the DN"
You could fool them and just say "their ext number is 7XXX" instead of "you must dial dest code 7 then the ext# (2XXX or 3XX)".

[clown]



________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top