BCM50 with T7316e/T24 and IP phones

[customnet]

If you have a BCM50 with a T7316e/T24 combo and IP phones, will the IP phones be accessed via the T24? Will the T24 show the IP phone in use?

Thanks.
Chris.

 

[MagnaRGP]

Just program an autodial button with the DN of the IP phones. Set type is irrelevant.

 

[customnet]

My engineering question is, I can have both types of phones on the system and see IP phones on the T24 coming off a digital T7316e, correct?

 

[gberger]

Correct, the ip phones status will show up on the T24.

 

[gm85]

From a telephony side, Digital Sets and IP Sets pretty much act the exact same way under the BCM.

Each set is assigned with a DN so pretty much if it can be done with a normal set, it can be done with an IP set (and vice versa).

So you can program a T7316e + T24 KIM with a DN button of an IP phone, as well as you can configure an IP Phone + KEM with a DN button of a T7316e phone.