BCM50 sets restarting

[rogalaska]

I recently patched a BCM50 rev 1 to the current patches. When I started the system had no patches on it at all. After patching the system the sets randomly restart themselves. They sets are on the BCM50 not an expansion cabinet and they all restart at the same time. I have had no luck locating any reference to this problem on the Nortel web site. I have done a hard reboot and this has not solved the problem.


My thinking was to perform a level 2 reset and start from scratch.

 

[gberger]

Have you verified if your amphenol is firmly attached to your bcm50? could it be that the vibrations makes one end of the amphenol poped out? Cause i never heard of that problem before.