BCM50 losing last no redial

[kevost]

Hey guys,

I don't get on here very much, but i've looked through countless threads on here that have helped me out in the past. I've got a real strange problem. On a bcm50 that i'm not sure of software release, but it was just installed last year, there is one extension that the last no redial stops working. I tried changing the port of the ext, and it didn't help. It will work fine then all of the sudden it will only dial 6 or 7 digits. We've tried changing phones as well. If you guys could help me out I would appreciate it.

Thanks,

Kevin

 

[curlycord]

Release 6 perhaps
Update the BCM's patches
See #4

BCM050.R600.CORE-TELEPHONY-44
=============================

1. Intercom key shows in use when there is no current call activity.
The intercom key will light up, as if on an active call, even
though the call in question is no longer active. This update
resolves reports of this issue.
wi00895197

2. CLID is not always displayed on sets.
Incoming central office PRI calls that tandem from one BCM over
SIP trunks to another BCM may intermittently display CLID on the
destination set. This update resolves reports of this issue.
wi00861084

3. BLF (Busy Lamp Field) indication on KEM's (Key Indicator Module)
does not update after a set performs a Page.
When a DN that has a BLF appearance on other sets performs a page,
the BLF appearance on the other sets will show busy. When the DN
releases the Page, the BLF appearance will still show in use. If
the DN that announced the Page, changes status (goes off-hook then
back on-hook) the BLF condition is reset. This update resolves
the issue of the BLF appearance showing busy after the DN
completes the Page.
wi00897403

4. Last number redial sends partial digits on analog trunks
When the Last number redial feature is invoked not all digits are dialed.
wi00890435






=----(((((((((()----=
curlycord

http://www.curlycord.com