BCM50 Hard Drive Replacement license.txt

[elchino2010]

Just replaced an R1 drive with R3. it took the license.txt
file but it doen't activate any of the keycodes.
I have rebooted the system with no results.
Can anyone tell what iam doing wrong ?
thanks in advance.

 

[curlycord]

Did you purchase an upgrade key code from 1 to 3?.





=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[elchino2010]

no, I just replaced the bad R1 drive with new R3 Drive

 

[BlueStuff]

you cant just swap the drives.
its a upgrade R1 --> R3.
Inorder for the licences to stick you need the upgrade key.

 

[BlueStuff]

ore re-image the drive to a R1

 

[elchino2010]

ok,
I installed a R2 drive and the license.txt works ok.
the reason why I need R3 is because of SIP lines.
Is there a patch to make this work ?

 

[curlycord]

Patch?
Patches fixes broken software.

You need software, release 3....or as already mention you need a key code to get to R3.

R1 to R2 is the only one that appears to be a free upgrade.....not sure why though.


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[curlycord]

Also I think you need Rls 5 for SIP Trunks.

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[elchino2010]

guys,
thanks for the input.
I got it.
thats why I came here for the right info.
Lots of smart people here.
saludos !

 

[Firebird Scrambler]

When you inputted your release 1 keycode on the release 3 disk. It might have stated that it had activated OK, but you should have checked the alarm section as you will have had a alarm stating that the keycode was invalid.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.