I was onsite yesterday and replaced a 50 and tried to minimize the downtime by copying and replacing the primary cabinet. The expansion cabinet was plugged in afterwards and today I found it's not being enabled by the main cabinet?? Do I have to reboot the main cabinet for it to be seen? I've tried disabling and re-enabling the expansion, but it just says enabling and the first port 501 says Unequipped and the 502-504 ports say disabled by user?? Reboot to fix it or is there some other way? I have to wait for a quiet time to reboot due to traffic at this time.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM50 Expansion Cabinet
- Thread starter canflyguy
- Start date
allworxguy
Vendor
Expansion cab needs a keycode. You have to migrate the codes, a copy of the config is not good enough. There are people here who can do that for you.
Marv ccna
Marv ccna
- Status
Similar threads
- Locked
- Question
- Question