Fax server needs DTMF tones from the BMC50?
History:
Using a PRI just installed a BCM50 configured for twenty-six T7316 sets and four (4) analog lines.
The BCM50 is configured to output the four (4) analog numbers out of a block of DID's.
Two (2) of these analog numbers are routed through a Patch Panel to a Fax Server.
Excluding the use of an Analog Station Module, is there a way to configure the BCM50 software to send DTMF tones for those two numbers?
History:
Using a PRI just installed a BCM50 configured for twenty-six T7316 sets and four (4) analog lines.
The BCM50 is configured to output the four (4) analog numbers out of a block of DID's.
Two (2) of these analog numbers are routed through a Patch Panel to a Fax Server.
Excluding the use of an Analog Station Module, is there a way to configure the BCM50 software to send DTMF tones for those two numbers?
