BCM50 and ARS

[JohnLarry71]

Hi ...

I have a BCM50 installed with 4 C.0 trunk connected, In the Routing table I built the 9 as a destination code to the land line and all the user restricted to use the 0 in filter 02, the new scenario is that i connect in line address no. 64 a GSM device (tellular) to be the user to call the mobile through this line ( 077xxx ... , 078xxx ... , 079xxx ... ), first i try to program this as Line/restriction each user dial 9 for land Line and 8 for mobile line but there is a lot of phone model T7000 and to configure line/restriction the line no.64 must be assigned and i cant assigned as a ring only .
another solution i try to solve this is to built in routing table as ARS ( 9 - 000 - pool A, LandLine), (907 - 001 - pool B, Mobile) but cant the system refuse.
How can I solve this ?

Thanks .

 

[snowman50]

use 9 route 001 Pool A
use 907 route 002 Pool B

dont use 000 as this is only for defaut in no other route used.

you may have to build other des codes

Basically what you are trying to tell the system is to use rout 001 for all calls except mobile starting with 07
whic will route out on route 002

90 route 001
901 route 001
902 route 001
903 route 001
904 route 001
905 route 001
906 route 001
907 ROUTE 002
908 route 001
909 route 001
91 route 001
92 route 001
93 route 001
94 route 001
95 route 001
96 route 001
97 route 001
98 route 001
99 route 001

 

[JohnLarry71]

Hi ...

Thank you Snowman, but what about the Absoblength ...


Thanks.

 

[snowman50]

Absorb 1
To remove the digit 9 in the dialling and sen the rest