VoiceOfJoe
MIS
Noticed several alarms on our BCM50 running 3.0.
These go back the last few days (as far as the log shows me) and happen several times a day.
For each alarm that read: Physical mmeory near or on its capacity. 5 seconds later I would see another corresponding alarm message: Physical memory recovered.
What's using up the BCM's memory?
Should I be alarmed (no pun intended) or are these just information. Any action required?
We haven't rebooted the BCM50 in 2-3 months, so a full restart may be in order. Is there a recommend restart interval that Nortel recommends (for good measure).
VOJ
These go back the last few days (as far as the log shows me) and happen several times a day.
For each alarm that read: Physical mmeory near or on its capacity. 5 seconds later I would see another corresponding alarm message: Physical memory recovered.
What's using up the BCM's memory?
Should I be alarmed (no pun intended) or are these just information. Any action required?
We haven't rebooted the BCM50 in 2-3 months, so a full restart may be in order. Is there a recommend restart interval that Nortel recommends (for good measure).
VOJ
