jamaster14
MIS
- Feb 19, 2010
- 149
we have a bcm50 rel 1.0 i have the software to upgrade it to rel 3.0. when i perform the upgrade will the installed keycodes be lost?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM50 1.0 to 3.0 upgrade -keycodes???
- Thread starter jamaster14
- Start date
- Status
Do you have all of your existing keycodes saved somewhere easily accessible? It always good to have them on hand just in case.
I believe when I upgraded from 3.0 to 5.0 the keycodes were still in place on the system. The one time I lost the keycodes was when I did a level 2 reset.
Joseph Sus Jr. Nortel Enthusiast
I believe when I upgraded from 3.0 to 5.0 the keycodes were still in place on the system. The one time I lost the keycodes was when I did a level 2 reset.
Joseph Sus Jr. Nortel Enthusiast
Canadadave
Programmer
Even if you lose the keycodes you can always get them from the Nortel keycode site again. I have had hard drives die in machines and had to download and reload the keycodes before without an issue.
When you activate your auth code to upgrade to 3.0 you should get one keycode back. Which should list all other items on your system. I would check your system with the Nortel KRS just to make sure that they show everthing you loaded on the system before you upgrade. The reason I say this is because 6 or 7 years ago alot of bad codes hit the market.
- Status
Similar threads
- Locked
- Question
- Locked
- Question