Ok guy's I'm having the problem of the PRI droping or locking up on my BCM the circuit has been tested the PRI card replaced and still it will drop every couple of day's some time's every day , would the IP set's cause the clocking to be off , what should the Codec be be set at ? it is set to Default and the IP terminal Global setting's is Default Codec is set to auto and the jitter buffer is auto , any ideas if this would cause Clocking issues ?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM45R1
- Thread starter cole06
- Start date
Is the bcm fully patched? is it a pri to the pstn or a point to point t-1 to another bcm site? Codecs are relatedto your ip telephony network. Choice in codec would depend on network bandwidth.
verify w/ telco that the bcm pri protocol matches that of telco. Clock source should be set to primary.
verify w/ telco that the bcm pri protocol matches that of telco. Clock source should be set to primary.
- Thread starter
- #3
- Status